Download presentation
Presentation is loading. Please wait.
1
Wind Energy
2
What is Wind? Wind is the stabiliztion movement of air between areas of high and low atmospheric pressure, created by the uneven heating of the Earth's surfaces: land, water, and air. The greater the pressure difference between these areas, the harder the wind blows. Wind also exists as the circulation of air around a high or low pressure area.
3
What is Wind Energy? Wind energy is the converting of wind power to electrical power through the use of windmills or turbines. electricity produced is sent to transformers where voltage is increased and sent to the power grid via transmission lines.
4
WIND ENERGY – WHERE IT COMES FROM?
All renewable energy (except tidal and geothermal power), ultimately comes from the sun The earth receives 1.74 x 1017 watts of power (per hour) from the sun About one or 2 percent of this energy is converted to wind energy (which is about times more than the energy converted to biomass by all plants on earth Differential heating of the earth’s surface and atmosphere induces vertical and horizontal air currents that are affected by the earth’s rotation and contours of the land WIND. ~ e.g.: Land Sea Breeze Cycle
5
Historical overview Wind has been used by people for over 3000 years for grinding grain and pumping water Windmills were an important part of life for many communities beginning around 1200 BC. Wind was first used for electricity generation in the late 19th century.
6
Early VAWTs
8
as early as the 14th century
(sail-wing turbine – Europe)
10
Livestock Water Power Match Storage Match Wind Statistics OK
11
Grandpa’s Knob Smith Putnam Machine 1941 Rutland, Vermont 1.25 MW
53 meters (largest turbine for 40 years) Structural steel Lost blade in 1945
12
WINDMILL DESIGN A Windmill captures wind energy and then uses a generator to convert it to electrical energy. The design of a windmill is an integral part of how efficient it will be. When designing a windmill, one must decide on the size of the turbine, and the size of the generator.
13
WIND TURBINES LARGE TURBINES:
Able to deliver electricity at lower cost than smaller turbines, because foundation costs, planning costs, etc. are independent of size. Well-suited for offshore wind plants. In areas where it is difficult to find sites, one large turbine on a tall tower uses the wind extremely efficiently.
14
SMALL TURBINES: Local electrical grids may not be able to handle the large electrical output from a large turbine, so smaller turbines may be more suitable. High costs for foundations for large turbines may not be economical in some areas. Landscape considerations
15
Wind Turbines: Number of Blades
Most common design is the three-bladed turbine. The most important reason is the stability of the turbine. A rotor with an odd number of rotor blades (and at least three blades) can be considered. A rotor with an even number of blades will give stability problems for a machine with a stiff structure. The reason is that at the very moment when the uppermost blade bends backwards, because it gets the maximum power from the wind, the lowermost blade passes into the wind shade in front of the tower.
16
WIND TURBINE GENERATORS
Wind power generators convert wind energy (mechanical energy) to electrical energy. The generator is attached at one end to the wind turbine, which provides the mechanical energy. At the other end, the generator is connected to the electrical grid. The generator needs to have a cooling system to make sure there is no overheating.
17
SMALL GENERATORS: Require less force to turn than a larger ones, but give much lower power output. Less efficient i.e.. If you fit a large wind turbine rotor with a small generator it will be producing electricity during many hours of the year, but it will capture only a small part of the energy content of the wind at high wind speeds. LARGE GENERATORS: Very efficient at high wind speeds, but unable to turn at low wind speeds. i.e.. If the generator has larger coils, and/or a stronger internal magnet, it will require more force (mechanical) to start in motion.
18
OTHER DESIGN CONSIDERATIONS
Winds are influenced by the ground surface at altitudes up to 100 meters. Wind is slowed by the surface roughness and obstacles. When dealing with wind energy, we are concerned with surface winds. A wind turbine obtains its power input by converting the force of the wind into a torque (turning force) acting on the rotor blades. The amount of energy which the wind transfers to the rotor depends on the density of the air, the rotor area, and the wind speed. The kinetic energy of a moving body is proportional to its mass (or weight). The kinetic energy in the wind thus depends on the density of the air, i.e. its mass per unit of volume. In other words, the "heavier" the air, the more energy is received by the turbine. at 15° Celsius air weighs about kg per cubic meter, but the density decreases slightly with increasing humidity.
19
OTHER DESIGN CONSIDERATION
A typical 600 kW wind turbine has a rotor diameter of meters, i.e. a rotor area of some 1,500 square meters. The rotor area determines how much energy a wind turbine is able to harvest from the wind. To be considered a good location for wind energy, an area needs to have average annual wind speeds of at least 12 miles per hour.
20
OTHER DESIGN CONSIDERATION
A windmill built so that it too severely interrupts the airflow through its cross section will reduce the effective wind velocity at its location and divert much of the airflow around itself, thus not extracting the maximum power from the wind. At the other extreme, a windmill that intercepts a small fraction of the wind passing through its cross section will reduce the wind’s velocity by only a small amount, thus extracting only a small fraction of the power from the wind traversing the windmill disk. Modern Windmills can attain an efficiency of about 60 % of the theoretical maximum.
21
POWER OF WIND *The power in wind is proportional to the cubic wind speed ( v3 ). WHY? ~ Kinetic energy of an air mass is proportional to v2 ~ Amount of air mass moving past a given point is proportional to wind velocity (v)
22
COST CALCULATIONS A typical 600 kW turbine costs about $450,000.
Installation costs are typically $125,000. Therefore, the total costs will be about $575,000. The average price for large, modern wind farms is around $1,000 per kilowatt electrical power installed. Modern wind turbines are designed to work for some 120,000 hours of operation throughout their design lifetime of 20 years. ( 13.7 years non-stop) Maintenance costs are about percent of the original cost, per year.
23
WIND POWER RESOURCE AREAS-US
24
WIND POWER RESOURCE AREAS-ALASKA & HAWAII
25
Advantages of Wind Power
The wind blows day and night, which allows windmills to produce electricity throughout the day. (Faster during the day) Energy output from a wind turbine will vary as the wind varies, although the most rapid variations will to some extent be compensated for by the inertia of the wind turbine rotor. Wind energy is a domestic, renewable source of energy that generates no pollution and has little environmental impact. Up to 95 percent of land used for wind farms can also be used for other profitable activities including ranching, farming and forestry. The decreasing cost of wind power and the growing interest in renewable energy sources should ensure that wind power will become a viable energy source in the United States and worldwide.
26
Disadvantages Advantages
The wind is not always predictable - some days have no wind. Suitable areas for wind farms are often near the coast, where land is expensive. Some people feel that covering the landscape with these towers is unsightly. Can kill birds - migrating flocks tend to like strong winds. However, this is rare, and we tend not to build wind farms on migratory routes anyway. Can affect television reception if you live nearby. Can be noisy. Wind generators have a reputation for making a constant, low, "swooshing" noise day and night, which can drive you nuts. Wind is free, wind farms need no fuel. Produces no waste or greenhouse gases. The land beneath can usually still be used for farming. Wind farms can be tourist attractions. A good method of supplying energy to remote areas.
27
When the wind doesn’t blow…
Do fossil-fired generating units have to be kept running on a standby basis in case the wind dies down? No. Wind speeds rise and fall gradually and the system operator has time to move other plants on and off line as needed. A 100-MW wind plant requires about 2 MW of conventional capacity to compensate for changes in wind. Wind can reliably provide 20% or more of our electricity.
28
Lifetime environmental impact
Manufacturing wind turbines and building wind plants does not create large emissions of carbon dioxide. When these operations are included, wind energy's CO2 emissions are quite small: about 1% of coal, or about 2% of natural gas (per unit of electricity generated).
29
Noise Noise used to be a very serious problem for the wind energy industry. annoying from as much as a mile away Aerodynamics and soundproofing have been improved significantly. Wind turbines operate when the wind is blowing, which tends to be louder than turbine noise. A modern operating wind farm at a distance of 750 to 1,000 feet is no noisier than a kitchen refrigerator or a moderately quiet room.
30
Shadow flicker A wind turbine's moving blades can cast a moving shadow on a nearby residence, depending on the time of the year and time of day. Normally, it should not be a problem in the U.S., because at U.S. latitudes (except in Alaska) the sun's angle is not very low in the sky.
31
Electrical power quality
Generally not a concern for low “penetration” Weak grids and grid reinforcement Problems may occur if a turbine is connected to a weak electrical grid, which can be reinforced. Power quality problems caused by wind farms are the exact mirror-image of connecting a large electricity user, (e.g. a factory with large electrical motors) to the grid. Electrical flicker Flicker = short lived voltage variations in the electrical grid which may cause light bulbs to flicker. Flicker may occur if a wind turbine is connected to a weak grid. Flicker can be reduced with proper turbine design.
32
TV and radio reception Modern small (residential) wind turbines will not interfere with communication signals. The materials used to make such machines are non-metallic (composites, plastic, wood). Small turbines are too small to create electromagnetic interference (EMI) by "chopping up" a signal. Large wind turbines can interfere with radio or TV signals if a turbine is in the "line of sight" between a receiver and the signal source. Alleviate the problem by: improving the receiver's antenna installing relays to transmit the signal around the wind farm
33
Saint Paul Island, Alaska
Turbine Size: 225 kW Turbine Manufacturer: Vestas Developer/owner: Northern Power Systems Capacity: .225 MW
34
Moorhead, Minnesota Turbine Size: 750 kW
Turbine Manufacturer: NEG Micon Developer: Moorhead Public Service Capacity: .75 MW
35
Sizes and Applications
Small (10 kW) Homes Farms Remote Application Intermediate ( kW) Village Power Hybrid Systems Distributed Power Large (660 kW - 2+MW) Central Station Wind Farms Distributed Power Community Wind
36
Drivers for Wind Power Declining Wind Costs Fuel Price Uncertainty
Federal and State Policies Economic Development Green Power Energy Security
Similar presentations
© 2023 SlidePlayer.com Inc.
All rights reserved.